Wood Floors on Concrete, Plumbing Repair and Finding Carpet Stains

This is a very full show covering many different topics. We start off commenting on a article in Fine Home Building magazine about wood floors over concrete, address two listener questions (one on leaky faucets and one on garbage disposals), and then we wrap up the show with a tip from Brian about how to find pet stains in carpet.

Wood floors on concrete

Can this be done? Sure it can. Brian and Paul comment on an article in Fine Homebuilding. The Author, Charles Peterson, discusses a technique that uses two layers of plywood and a vapor barrier to create a stable, floating, subfloor for installation of your finished floor. Check it out and listen to The Handyguys comments in the podcast.

Drippy faucets

The Handyguys love getting questions where the answer is simple and inexpensive. We received this question from Cheryl

I have a leaky bathtub faucet, it started dripping and it has gotten worse, do I need to replace the entire faucet? My house was built in 1953 and I’m guessing the faucet is probably that old too! It consists of two knobs, one of hot and cold and the spigot of course. I think both the hot and cold are leaking, I can’t really determine which one it is! Thanks for any help you can provide.

Cheryl – Thanks for your question. NO, you do not need to replace the faucet. The fix is pretty simple. We assume you mean the drip is coming from the spout, not from behind the handles. Our friends over at hammer zone have put together some instructions. I’ll let you read them instead of my recreating the steps here. Check out HammerZone’s how to replace a washer article and listen to our podcast for details.

There could be a few other issues. Give the washer replacement a try first, its easy to do.

Some possible pitfalls

• The washer screw is broken off
• The seat (what the washer presses against) is damaged
• Parts are corroded preventing removal
• The handle you have may remove differently than in the pictures at hammerzone

If you have trouble please let us know. You can hear our discussion of the issue in the podcast.

Garbage Disposal Smells

This stinky issue keeps generating interest. We have received many tips and tricks. We thought we would answer Dave’s question and pass along his tip.

I always shut off the circuit breaker to the disposal anytime I am going to stick my hand in there. Just to be sure that it will not turn off.

Have you guys used Draino? I had a problem where soft foods weren’t getting shredded enough to go down the drain so I started getting an odor. I poured draino down there and after it sat for awhile I ran it again and the food and smell were gone. Do you know of any problems in using draino in a disposal. ex corrosion or other problems?

Good tip about the circuit breaker Dave, better safe than sorry. As for Draino. Yes and No. It depends on which draino product you are considering. Check the label. The crystals are not recommended for garbage disposers, the gel is fine according to the manufacture. Bottom line, check the label.

The Handyguys answer a question about chainsaws and toilets!

Brian and Paul receive lots of good questions.   When we received a question from Suzanne about her toilet not flushing properly, we thought it would be an easy solution. However, upon studying the issue more closely, we realized that she had a non-standard toilet.

Here is what she asked:

 We are having a problem with our toilet not flushing properly.  The handle became hard to push down to flush, and eventually broke. We replaced the handle 3 times now but all have broken within a few uses.  It seems the handles aren’t strong enough to lift the flush valve.  It’s like it has a strong suction keeping it closed. Any suggestions as to what the problem is and how to fix it?

Our first thought was that the flapper valve was sticking and making it difficult to release with the handle.  We also suggested that Suzanne look at the handle mechanism itself to make sure it was moving freely.  But soon we found out that this toilet does not have a standard flapper valve.  Check out the picture:

This is not a common setup. The flush mechanism is made by Mansfield and uses non-standard parts.  If the entire flush mechanism is at fault, you have to remove the entire tank to remove the parts.  However, if just the flush seal is at fault, it can be replaced for about $2.00.

What was the solution?  Check out the podcast. The Handyguys also produced a show earlier in the year on general toilet troubleshooting,check it out here http://www.handyguyspodcast.com/58/episode-8-in-the-toilet

Another listener emailed about whether a particular chainsaw was a good buy.  Before we answer the question (I am not sure we ever answered the question?), we discussed two basic issues related to chainsaws:

1)  Should you buy, borrow, rent or steal a chainsaw?

 2) If buying, how do you proceed to identify the chainsaw that is right for you?

 There are two main types of chainsaws, electric and gas powered.  The electric are cheaper and less powerful but handy if you have a small lawn and only need to occasionally cut branches and such.  But be careful!  Brian recounts a dangerous episode with an electric chainsaw.

Gas powered chainsaws can do much bigger jobs and are not limited by the length of your extension cord.  If you are going to buy a gas powered chainsaw, it is not worth skimping with a cheap brand.  Look for a Husqvarna or Stihl so that you don’t spend all day trying to get the saw started.

Check out he full podcast for more recommendations and safety precautions when dealing with chainsaws.

In next week’s show we will take a closer look at Mighty Putty!  If you have any suggestions on how mighty putty can be used, please let us know.